It’s a notorious phenomenon among car enthusiasts: you buy a new set of alloy wheels with the exact specified bolt pattern (PCD), centre bore and ET (Offset). Yet when test-fitting, the back of the spokes rub against the brake caliper. How can a wheel that fits perfectly on paper physically collide with the braking system in practice?
In this technical guide from Wheels 'N Customs we explain why the ET value only tells you something about the mounting face, how spoke shapes (Concavity) affect brake-caliper clearance, what the crucial X-Factor (Brake Clearance) means and how to avoid this problem on sporty cars (Golf R, Audi RS, BMW M, Toyota Yaris GR) or with Big Brake Kits.
The Einpresstiefe (ET value) measures only the distance between the centre of the wheel and the flat mounting face against the hub. It gives information about how far the wheel sits inwards or outwards relative to the wheel arch, but says nothing about the three-dimensional shape of the spokes on the inner side of the wheel.
| Track & Fit Variables | What Does This Value Measure? | Influence on Caliper? | Critical Risk |
|---|---|---|---|
| ET Value (Offset) | Distance from mounting face to the exact midline of the wheel. | Indirectly | Interference with strut or wheel-arch lip |
| X-Factor (Brake Clearance) | The free space between the mounting face and the back of the spokes. | 100% Directly Determinative | Contact with the brake caliper |
| Spoke Profile (Concavity) | The degree to which the spokes curve inward (Flat, Mid, Deep Concave). | Very Large | Deep concavity reduces brake clearance |
| Rim Bed & Width (J-Width) | The total width of the rim bed in inches. | Moderate | Inner and outer clearance to the wheel arch |
Modern tuning wheels (from brands like Concaver, Japan Racing or Wheelforce) are popular for their 'Deep Concave' design, where the spokes plunge deep towards the centre from the outer lip. However, this hollow design brings a technical disadvantage for vehicles with large brake calipers:
With a 'Flat Face' or straight spoke design the spokes rise steeply from the hub. This creates a large recessed area on the inside of the wheel (high X-factor). This type of wheel will usually fit easily over large 4‑pot or 6‑pot calipers such as Audi RS or Brembo systems.
With 'Deep' or 'Extreme' Concave wheels the spokes angle inwards from the rim lip towards the mounting face. Exactly where the large caliper sits, the spokes come closest to the hub. This can cause the spoke to scrape or jam against the side of the brake caliper.
If test-fitting shows the wheel contacts the caliper, but you want to keep the wheel model, there are two professional solutions depending on the required clearance:
In many cases a minimum extra clearance of 3 mm to 5 mm is sufficient to keep the spokes clear of the brake caliper. By fitting a high-quality hub-centric spacer you push the entire wheel slightly outwards. Note: always check that there is sufficient thread length remaining on the wheel bolts (at least 6.5 to 8 full turns when tightened) or fit extended wheel bolts.
For brands with custom production lines (such as JR Wheels, Concaver or RFC Custom Forged) we order so-called 'Blank' wheels. The factory calculates the ideal combination of spoke profile and ET value in advance, after which the centre is milled exactly to size for your specific brake system.
Unsure whether the desired concave wheel set clears your sports brakes or Big Brake Kit? In our professional workshop in Nijkerk we carry out expert testfits. We check track width, the thread length of the wheel bolts and ensure a 100% guaranteed and vibration-free installation.
Our fitment experts will calculate the correct X-factor and wheel profiles immediately based on your car details and brake system.
We use cookies to optimise your user experience, analyse web traffic and for marketing purposes. If you agree to our use of cookies, click "Allow cookies".